BRIEF INTRODUCTION OF THE CONTROL SYSTEM MIK-el

CanBus – serial connection of the switchboard panel and the inspection ride box = saving the 24-wire drag cable and faults elimination.
Power supply of processors and their circuits (9V AC) isolated from operating 24V DC = elimination of problems, HW protection during construction and operation (short circuits, voltage peaks of switching elements, etc.).
Simple and intuitive setup of parameters and controls – all in Czech language.
Two integrated information displays on the main card and status LED on inputs and outputs.
Sophisticated functions lift testing (blocking floor switches, blocking door opening, random ride…) – convenient for servicing.
Outputs to gray, binary and 7-segment displays for the cabin and for individual floors without the need for an extension card or „expanders“.
Possibility of door pre-opening and alignment for both hydraulic and cable lifts!
Possibility of shaft copying cabin position determination) using the machine encoder and a special magnetic sensor.
Possibility of simple connection of emergency cabin ride with UPS in case of power failure.
Advantageous price.
There is no need for an external programming device programming is done by the buttons).
Accurate adjustment of cabin arrival to the station is possible with switchboard buttons, there is no need to move the magnets in the shaft.
Certification against unintended movement of the car according to EN 81-20